Beck/Arnley 104-1351 front engine mount for the 1995-2004 Toyota Tacoma 4-cylinder 2.4L or 2.7L and other vehicles helps support and locate the engine and isolates its vibration.
- Materials chosen to dampen engine vibration
- Built for underhood conditions
- Application-specific design for each vehicle it is listed for
Quick facts
- Part: Beck/Arnley 104-1351 engine mount
- Fits: the 1995-2004 Toyota Tacoma 4-cylinder 2.4L or 2.7L and other vehicles
- Position: Front
- Condition: New
A worn engine mount can show up as a clunk on acceleration, deceleration or shifting, vibration at idle, or cracked or separated rubber you can see with the engine off. Those signs alone do not prove the mount is the problem, since a worn transmission mount is another common source.
Fits
The 1995-2004 Toyota Tacoma 4-cylinder 2.4L or 2.7L, the 1988-1995 Toyota 4Runner V6 3.0L and the 1996-2000 4Runner 4-cylinder 2.7L take two of these mounts each, and the part fits more vehicles besides. The mount type is an exact match to OE for each application.
Specifications
- Position: Front
- Condition: New
Interchange: 9080 · 1236135090 · 1236165010 · 23051024748 · 23051036598 · 601138 · 1236135091 · 1236165011 · EM8164 · EM9080
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
9080, 1236135090, 1236165010, 23051024748, 23051036598, 601138, 1236135091, 1236165011, EM8164, EM9080
Frequently Asked Questions
Will this engine mount fit a 1995-2004 Toyota Tacoma 4-cylinder 2.4L or 2.7L?
Yes. Beck/Arnley 104-1351 is a front engine mount for the 1995-2004 Toyota Tacoma 4-cylinder 2.4L or 2.7L, two per truck; for any other vehicle, run it through the "Vehicles it fits" section.
Is this one of the engine mounts for the 1988-1995 Toyota 4Runner V6 3.0L and the 1996-2000 4Runner 4-cylinder 2.7L?
Yes. Beck/Arnley 104-1351 is listed for both, and each of them takes two.
Is the mount type the same as the original?
Yes. The mount type is an exact match to OE, whether the application calls for a hydraulic, vacuum or active mount.
How can I tell if a front engine mount has gone bad?
Listen for a clunk when you accelerate, let off or shift, and notice vibration at idle; with the engine off, look for cracked or separated rubber on the mount.
Does Beck/Arnley 104-1351 replace EM9080?
Yes. EM9080 is one of the cross-reference numbers for this mount, along with 9080 and 1236135090.
