Beck/Arnley Steering Tie Rod End P/N:101-8511
Tighten up loose, wandering steering with the Beck/Arnley tie rod end 101-4919, a front outer tie rod end built as a direct replacement for Original Equipment applications on foreign nameplates. This Beck/Arnley steering tie rod end drops in on the 1994-1996 Mercedes-Benz C220, 1997-2000 C230, 1994-2000 C280, 1995-1997 C36 AMG, 1998-2000 C43 AMG, 1998-2002 CLK320, 1999-2003 CLK430, 2001-2002 CLK55 AMG, 1998-2004 SLK230, 2002-2004 SLK32 AMG and 2001-2004 SLK320 — see the Buyer's Guide tab for engine-level fitment.
The tie rod end connects the steering linkage to the steering knuckle, transferring steering input to the wheel while allowing suspension travel. Worn units show up as loose or wandering steering, uneven tire wear, and a knocking or clunking through the steering.
Tie rod ends install as left/right pairs on the axle; replacing both sides together helps keep steering response even.
Interchange: 45A0773 · 0013307735 · L1254701 · 61235016 · 534548 · 43933016054 · 43933016500 · 43933056500 · TO28005 · TO28005XL · MS3317 · 0013307435 · MES3317 · 4011773 · ES3317 · ES3642
This part cross-references / interchanges with the following part numbers:
What does this Beck/Arnley tie rod end do?
It connects the steering linkage to the steering knuckle, transferring steering input to the wheel while allowing suspension movement. This is a front outer tie rod end.
Will this fit my Mercedes-Benz?
It is a direct replacement for listed applications including the 1994-2000 C280, 1998-2002 CLK320 and 1998-2004 SLK230. Check the Buyer's Guide tab for the full vehicle and engine list.
How do I know if my tie rod end is worn?
Signs a tie rod end may need replacing include loose or wandering steering, uneven tire wear, and a knocking or clunking felt through the steering. Have the cause diagnosed before replacing.
Is the ball joint greased and does it use a wrench flat?
Yes. The ball joint is pre-greased, and an easy-access wrench flat lets you use a socket for quicker installation and removal.
Should I replace both sides at once?
Tie rod ends install as left/right pairs on the axle. This listing is for one unit; replacing both sides together is recommended to keep steering response even.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.