Keep your steering tight and predictable with the Beck/Arnley tie rod end (P/N 101-7656), a front outer steering tie rod end that connects the steering linkage to the knuckle so your inputs at the wheel translate into precise directional changes. It's a direct-fit replacement for the 2007-2018 Acura RDX — see the "Vehicles it fits" section to confirm the engine for your vehicle.
Beck/Arnley focuses on foreign-nameplate applications with special attention to form, fit, and function, sourcing OE-quality parts through a trusted global network so you can install with confidence.
- OE-matched: Built to match the original equipment form, fit, and function.
- Corrosion protection: Coated or plated to resist corrosion.
- Pre-greased ball joint: The ball joint arrives pre-greased.
- Easy installation: An easy-access wrench flat lets you use a socket for quick installation and removal.
- Full ball stud: Uses a full ball stud.
Signs this tie rod end may need replacing include loose or wandering steering, uneven tire wear, or clunking and play felt through the wheel. Because tie rod ends are used on both sides, inspect the opposite side and replace both together when needed for balanced steering.
Interchange: 53540STKA01 · 53540TX4A01 · 53540TX4A02 · 61240101 · TO50065 · ES801172 · ES4869E · MS60641
This part cross-references / interchanges with the following part numbers:
53540STKA01, 53540TX4A01, 53540TX4A02, 61240101, TO50065, ES801172, ES4869E, MS60641
Frequently Asked Questions
Does part 101-7656 fit the 2007-2018 Acura RDX?
It's a direct-fit replacement for the 2007-2018 Acura RDX front outer position. Check the "Vehicles it fits" section to confirm the correct engine for your vehicle.
Is the ball joint pre-greased?
Yes. The ball joint arrives pre-greased from the factory, so it's ready to install.
What are signs my tie rod end needs replacing?
Common signs include loose or wandering steering, uneven tire wear, and clunking or play felt through the steering wheel. Have the cause diagnosed before replacing.
Does it resist corrosion?
Yes. It's coated or plated to provide corrosion protection.
Do I need to replace both sides?
Tie rod ends are used on both sides, so inspecting and replacing both sides together is recommended for balanced, even steering, though each is sold individually.
