Keep steering response tight and precise with the Beck/Arnley Steering Tie Rod End 101-7954 (also written 1017954), a front inner tie rod end that drops in as a direct-fit replacement for the 2012-2016 Honda CR-V — see the Buyer's Guide tab for engine-level fitment. This tie rod end connects the steering system to the wheel, transmitting steering input and helping maintain proper wheel alignment; worn units are a common cause of loose or wandering steering, uneven tire wear, and clunking or play through the wheel when a tie rod end is the source.
If a failed front inner tie rod end is behind your steering play, this replaces it. We recommend a professional alignment after installation.
Interchange: 61240039 · 53010T0AA01 · TI59230 · TI59230XL · EV800937 · ES4906E · MS60717
This part cross-references / interchanges with the following part numbers:
Will this tie rod end fit my vehicle?
It is a direct-fit replacement for the 2012-2016 Honda CR-V. Check the Buyer's Guide tab to confirm the application for your specific vehicle.
Is this an inner or outer tie rod end?
The catalog lists this as a front inner tie rod end. Confirm the position needed for your vehicle before ordering.
Does the ball joint come greased?
Yes. The ball joint is pre-greased, and a full ball stud handles the load-bearing steering connection.
What are signs a tie rod end may need replacing?
Loose or wandering steering, uneven tire wear, and clunking or play through the wheel can indicate a worn tie rod end. Diagnose the cause before replacing.
Do I need an alignment after installation?
Yes, we recommend a professional wheel alignment after replacing a tie rod end to help maintain proper alignment and even tire wear.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
