Tighten up loose, wandering steering on your Mitsubishi with the Beck/Arnley Steering Tie Rod End 101-8601 (also written 1018601). This front inner tie rod end connects the steering linkage to the steering system, transmitting motion so the front wheels turn together and hold their aim. It installs as a direct-fit replacement for the 2014-2015 and 2017-2024 Mitsubishi Mirage and the 2017-2024 Mitsubishi Mirage G4 — see the Buyer's Guide tab for engine-level fitment.
Worn tie rod ends can show up as loose or imprecise steering, uneven front tire wear, or a clunk and play in the steering. If a failed front inner tie rod end is the cause, this Beck/Arnley unit replaces it. Have your alignment checked after installation.
Interchange: 61246033 · TI67150PR · TI67150 · EV801372 · MS80739 · 4422A098
This part cross-references / interchanges with the following part numbers:
What vehicles does this tie rod end fit?
It fits the 2014-2015 and 2017-2024 Mitsubishi Mirage and the 2017-2024 Mitsubishi Mirage G4. Check the Buyer's Guide tab to confirm your vehicle.
What position is this tie rod end?
It is a front inner tie rod end that connects the steering linkage to the steering system on the listed applications.
Does it come pre-greased?
Yes. The ball joint arrives pre-greased and ready to install, and the part is coated or plated to resist corrosion.
What are signs my tie rod end may need replacing?
Loose or imprecise steering, uneven front tire wear, and a clunk or play in the steering can indicate a worn tie rod end. Diagnose the cause before replacing.
Do I need an alignment after installing this?
An alignment is recommended after replacing a tie rod end so the front toe is set correctly and tire wear stays even.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
