Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-4855
$108.99
(You save)
Keep the front suspension properly located and steering tight with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-4855. This front right upper control arm drops in as a direct replacement for the 2001-2003 Acura CL, 1999-2003 Acura TL, and 1998-2002 Honda Accord — see the Buyer's Guide tab for engine-level detail.
Complete assembly: the control arm comes with its ball joint for a complete installation.
OE form, fit and function: engineered as a direct replacement matched to the original equipment for these applications.
Construction: steel, iron, or aluminum construction for durability and rust/corrosion resistance.
Hardware: new hardware and bushings included where applicable; application specific for this vehicle.
The upper control arm locates the wheel and, through its integrated ball joint, provides a pivot point for steering and suspension travel. Signs the original may need replacing include clunking or knocking over bumps, loose or wandering steering, and uneven front tire wear. If a worn control arm or ball joint is the cause, this assembly replaces both in one part. Because these wear parts install per side, inspect and service the opposite side as needed for balanced handling.
It fits the 2001-2003 Acura CL, 1999-2003 Acura TL, and 1998-2002 Honda Accord. Check the Buyer's Guide tab to confirm the correct application for your vehicle.
What position is this control arm for?
This is the front right upper control arm and ball joint assembly for the listed applications.
Does the ball joint come with the control arm?
Yes. The control arm comes with its ball joint for a complete installation, so both are replaced together as one assembly.
What are signs my control arm or ball joint needs replacing?
Common signs include clunking or knocking over bumps, loose or wandering steering, and uneven front tire wear. Diagnose the cause before replacing.
Is mounting hardware included?
New hardware and bushings are included where applicable, and the assembly is application specific for this vehicle. Consult the service information for correct fasteners and torque.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-4855
Keep the rear suspension precisely located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8243 — the rear right upper rearward arm for the 2005-2012 Acura RL. It arrives as...
Keep the front suspension located and quiet with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-6326), a direct-fit replacement for the front right upper position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
