Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-5111
$70.99
(You save)
Tighten up worn rear suspension geometry with the Beck/Arnley control arm and ball joint assembly (P/N 102-5111, also written 1025111), a rear left upper unit designed as a direct replacement for OE applications. It installs on the 1993-1995 and 1997-2001 BMW 740I, the 1993-2001 BMW 740IL, the 1995-2001 BMW 750IL, and the 2000-2003 BMW Z8 — see the Buyer's Guide tab to confirm your engine.
OE form, fit and function: engineered to match the original arm so it locates the wheel and lets the suspension move through its travel.
Ball joint included: the control arm comes with its ball joint for a complete installation.
Durable construction: built from steel, iron, or aluminum depending on the application, for durability and rust/corrosion resistance.
Hardware & bushings: new hardware and bushings included where applicable; it is application specific for this vehicle.
Clunking over bumps, uneven tire wear, and loose or wandering steering can be signs a worn control arm or ball joint may need replacing. If a failed arm or ball joint is the cause, this assembly replaces it in the rear left upper position — diagnose the cause first.
It is the rear left (driver-side) upper control arm with an integrated ball joint. Order the matching part for other positions on your vehicle.
Which vehicles does this Beck/Arnley control arm fit?
It fits the 1993-1995 and 1997-2001 BMW 740I, 1993-2001 BMW 740IL, 1995-2001 BMW 750IL, and 2000-2003 BMW Z8. Check the Buyer's Guide tab for engine-level detail.
Is this the correct BMW 740I control arm?
Yes — it fits the 1993-1995 and 1997-2001 BMW 740I in the rear left upper position. See the Buyer's Guide tab to confirm your engine.
Does it include the ball joint and hardware?
The control arm comes with its ball joint for a complete installation, and new hardware and bushings are included where applicable.
What are signs this control arm may need replacing?
Clunking over bumps, uneven tire wear, and loose or wandering steering can indicate a worn control arm or ball joint. Have the cause diagnosed before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-5111
Locate the front wheel and anchor the lower suspension with the Beck/Arnley Control Arm and Ball Joint Assembly 102-8289, a G37 control arm that installs in the front left lower position on your...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
