Keep the front wheel located and tracking true with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-5468 — a direct-fit Kia Sorento control arm that locates the front-left (driver's-side) upper suspension and connects it to the steering knuckle through its integrated ball joint. It installs as a direct-fit replacement for the 2007-2009 Kia Sorento (see the Buyer's Guide tab for engine-level fitment). If a worn arm or ball joint is behind your clunking over bumps, loose or wandering steering, or uneven front tire wear, this assembly replaces it.
This is an application-specific control arm and ball joint assembly for the listed vehicle.
Interchange: 8500374 · 62250024 · KIH213 · 544103E100 · RK80343 · CMS901059 · JTC1323
This part cross-references / interchanges with the following part numbers:
What position does this Beck/Arnley control arm fit?
It is the front-left (driver's-side) upper control arm and ball joint assembly for the 2007-2009 Kia Sorento. Confirm your side and position against the vehicle before ordering.
Does the Kia Sorento control arm come with the ball joint?
Yes. The control arm ships with the ball joint pre-installed, so both wear points are replaced together in a single assembly.
Will this fit my Kia Sorento?
It is a direct-fit replacement for the 2007-2009 Kia Sorento. See the Buyer's Guide tab for full engine-level fitment details.
What are the signs I need a Kia Sorento control arm replacement?
Clunking over bumps, loose or wandering steering, and uneven front tire wear can point to a worn arm or ball joint. Diagnose the cause before replacing.
Is mounting hardware included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any originals may be reused.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
