Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-6142
$240.99
(You save)
Tighten up your front-suspension geometry with the Beck/Arnley control arm and ball joint assembly (P/N 102-6142), a front right lower unit that drops in as a direct replacement for the 2003-2008 Infiniti FX35 and 2003-2008 Infiniti FX45. The control arm locates the front wheel and sets the suspension's pivot points, while the integrated ball joint allows the steering knuckle to move through its travel — making this a straightforward Infiniti FX35 lower control arm replacement.
Complete assembly: the control arm comes with the ball joint for a complete installation.
OE match: engineered to match OE form, fit and function for the listed applications.
Durable build: steel, iron, or aluminum construction for durability and rust/corrosion resistance.
Hardware: new hardware and bushings included where applicable.
If worn bushings or a loose ball joint in the original front lower arm are behind clunking over bumps, a wandering feel, or uneven tire wear, this Beck/Arnley control arm addresses the cause when it's the failed component. A ready-to-bolt option if you're searching for a lower control arm Infiniti FX35 owners can install with confidence.
What vehicles does this Beck/Arnley control arm fit?
It's a front right lower assembly for the 2003-2008 Infiniti FX35 and 2003-2008 Infiniti FX45. See the Buyer's Guide tab to confirm the correct engine for your vehicle.
Does this assembly include the ball joint?
Yes—the control arm comes with the ball joint for a complete installation, and new hardware and bushings are included where applicable.
What are signs I need a lower control arm replacement on my Infiniti FX35?
Clunking over bumps, a wandering feel, or uneven tire wear can be signs the control arm bushings or ball joint are worn. Diagnose the cause before replacing.
What is this Infiniti FX35 control arm made of?
It uses steel, iron, or aluminum construction for durability and rust/corrosion resistance, and is built to match OE form, fit and function.
Do I need to replace both sides?
This listing is for one front right lower control arm. Inspect the opposite side and replace it too if it shows similar wear for balanced suspension performance.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-6142
Keep the front wheel precisely located and free to pivot through steering and suspension travel with the Beck/Arnley control arm 102-6654, engineered to drop in like the original front left lower arm...
Steady the front end and keep steering response tight with the Beck/Arnley control arm and ball joint assembly (P/N 102-7072). This front left lower unit drops in as a direct-fit replacement for the...
Bolt the steering and ride quality back to factory spec with the Beck/Arnley control arm assembly 102-7691, a front right lower unit that installs as a direct-fit replacement on the 2002-2006...
Sharpen steering response and control uneven tire wear with the Beck/Arnley Control Arm and Ball Joint Assembly 102-5286 — a direct-fit front left (driver's side) lower Nissan Altima control arm that...
Locate the front wheel precisely and let it steer and travel smoothly with the Beck/Arnley control arm and ball joint assembly (MPN 102-7797, also written 1027797). This front lower unit ships as a...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
