Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-6429
$250.99
(You save)
Help restore tight, controlled steering and address worn-bushing clunks with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-6429. It installs as a direct-fit replacement for the front right (passenger-side) lower position on the 2005-2015 Toyota Tacoma, arriving as a pre-assembled control arm and ball joint for a complete installation.
Complete corner: The control arm comes with the ball joint already fitted, so the locating arm and pivot are replaced together in one unit.
Durable construction: Built from steel, iron, or aluminum depending on the application for strength and rust/corrosion resistance.
OE match: Engineered as a direct replacement for Original Equipment applications with attention to form, fit, and function.
Included where applicable: New hardware and bushings are supplied where applicable for this application-specific part.
This assembly helps support and locate the front suspension and control wheel geometry. Signs it may need replacing include clunking or knocking over bumps, loose or wandering steering, and uneven front tire wear. Diagnose the cause before replacing. Replacing the matching part on the opposite side at the same time helps keep handling balanced.
It is a direct-fit front right (passenger-side) lower control arm and ball joint assembly for the 2005-2015 Toyota Tacoma. See the Buyer's Guide tab to confirm your vehicle.
Does it come with the ball joint installed?
Yes. The control arm comes with the ball joint already fitted, so both the locating arm and the pivot are replaced together in one complete unit.
What is this assembly made of?
It is built from steel, iron, or aluminum depending on the application, providing strength along with rust and corrosion resistance.
Are hardware and bushings included?
New hardware and bushings are included where applicable for this application-specific part. Consult the vehicle service information for the correct fasteners and torque.
Should I replace both sides at once?
Replacing the matching part on the opposite side at the same time is recommended to keep suspension wear and handling balanced, though each side is sold individually.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-6429
Keep the rear suspension precisely located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8243 — the rear right upper rearward arm for the 2005-2012 Acura RL. It arrives as...
Keep the front suspension located and quiet with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-6326), a direct-fit replacement for the front right upper position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
