Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-6430
$274.99
(You save)
Restore precise steering and a solid front end with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N:102-6430). This is a front left lower unit that locates the wheel and pivots the suspension, with the ball joint integrated for a complete installation. It drops in as an application-specific replacement for the 2005-2015 Toyota Tacoma — see the Buyer's Guide tab for engine-level fitment.
Direct replacement: Designed to match OE form, fit, and function for foreign-nameplate applications.
Complete assembly: The control arm comes with the ball joint pre-mounted, so you replace both wear points in one step.
Durable construction: Built from steel, iron, or aluminum for strength and rust/corrosion resistance.
Hardware & bushings: New hardware and bushings included where applicable.
Worn control arm bushings or a failing ball joint can bring on clunking over inputs, wandering or loose steering, and uneven tire wear. If the original front left lower arm or its ball joint is the cause, this assembly replaces both. Replace the matching side and have an alignment performed after installation.
It is an application-specific replacement for the 2005-2015 Toyota Tacoma. Check the Buyer's Guide tab to confirm engine-level fitment for your vehicle.
Which position is this assembly?
It is the front left (driver's side) lower control arm and ball joint assembly.
Does the ball joint come installed?
Yes. The control arm comes with the ball joint for a complete installation, so you replace both wear points at once.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any may be reused.
What are signs this part may need replacing?
Clunking over bumps, wandering or loose steering, and uneven tire wear can point to a worn control arm bushing or ball joint. Diagnose the cause before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-6430
Keep the rear suspension precisely located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8243 — the rear right upper rearward arm for the 2005-2012 Acura RL. It arrives as...
Keep the front suspension located and quiet with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-6326), a direct-fit replacement for the front right upper position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
