Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-6449
$182.99
(You save)
Keep your front suspension located and steering under control with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-6449) — a front right lower Honda Odyssey control arm that locates the wheel and pivots the suspension while its integrated ball joint connects the steering knuckle. It drops in as a direct-fit replacement for the 2005-2006 Honda Odyssey (see the Buyer's Guide tab for engine details), delivering the front right lower unit as a matched assembly.
Control arm with ball joint: the arm ships with its ball joint pre-installed for a complete installation.
Matches OE form, fit and function: designed as a direct replacement for the Original Equipment application.
Durable construction: built from steel, iron, or aluminum for durability and rust/corrosion resistance.
Hardware & bushings: includes new hardware and bushings where applicable, and is application specific for this vehicle.
Signs this part may need replacing include clunking on acceleration, deceleration, or over bumps, uneven front tire wear, wandering steering, or play in the ball joint. If a worn control arm or ball joint is the cause, this assembly replaces it.
What vehicle does the Beck/Arnley 102-6449 control arm and ball joint assembly fit?
It is a direct-fit replacement for the 2005-2006 Honda Odyssey, front right lower position. See the Buyer's Guide tab to confirm the engine for your vehicle.
Does this Honda Odyssey control arm come with the ball joint?
Yes. The control arm ships with its ball joint pre-installed as a complete assembly for a single-piece installation.
What is this Beck/Arnley part made of?
It is constructed of steel, iron, or aluminum for durability and rust/corrosion resistance, and is application specific for this vehicle.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Check the vehicle service information for the correct fasteners and whether any may be reused.
What are signs my 2006 Honda Odyssey control arm needs replacing?
Clunking on acceleration, deceleration, or over bumps, uneven front tire wear, wandering steering, or ball joint play. Diagnose the cause before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-6449
Replace a worn Nissan Versa control arm and bring back steady, quiet handling with the Beck/Arnley Control Arm with Ball Joint (P/N 102-8296, also written 1028296). This front right lower control arm...
Keep the front wheel properly located and the steering knuckle pivoting freely with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (102-6818). This Nissan Sentra control arm drops in...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
