Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-6584
$156.99
(You save)
Locate and support the front suspension of your Lexus with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-6584. This front left upper control arm arrives with its ball joint pre-installed for a complete corner, dropping in as a direct-fit replacement for the 2001-2006 Lexus LS430 (see the Buyer's Guide tab for engine-level fitment). Beck/Arnley builds parts to replace Original Equipment on foreign nameplates with close attention to form, fit, and function.
Complete corner: the control arm comes with the ball joint already fitted, so you replace the pivoting link and its joint in one step.
OE-matched: engineered to match the original part's form, fit, and function for the listed application.
Durable construction: built from steel, iron, or aluminum depending on the application for strength and rust/corrosion resistance.
Application specific: any hardware and bushings are included where applicable for this vehicle.
The control arm locates the wheel and lets the suspension travel, while the ball joint allows the knuckle to pivot for steering. Signs the original may need replacing include clunking or knocking over the front end, wandering steering, uneven tire wear, or a worn/torn ball-joint boot.
This part cross-references / interchanges with the following part numbers:
521071, 4863059045, RK641531, CMS86195
Frequently Asked Questions
What vehicle does this control arm assembly fit?
It is a direct-fit replacement for the 2001-2006 Lexus LS430. Check the Buyer's Guide tab and confirm the fitment matches your vehicle before ordering.
Does it include the ball joint?
Yes. The control arm comes with the ball joint already installed, so you replace the link and its pivot joint together as one complete corner.
What position is this control arm for?
It is the front left upper control arm and ball joint assembly for the listed Lexus LS430 application.
What is it made of?
Depending on the application, Beck/Arnley builds it from steel, iron, or aluminum for strength and rust/corrosion resistance.
What are signs my control arm or ball joint needs replacing?
Common signs include clunking over bumps, wandering or loose steering, uneven front tire wear, or a torn ball-joint boot. Diagnose the cause before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-6584
Tighten up your Lexus's ride and restore precise wheel location with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8199. This rear left upper unit installs as a direct-fit...
Keep the front suspension properly located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8103, a front right lower unit that installs as an application-specific replacement...
Restore steering precision and quiet the clunks with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-5535, also written 1025535). This front left upper control arm arrives...
Keep your front suspension properly located and your steering tight with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8380. This front right lower assembly drops in as a direct...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
