Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7151
$124.99
(You save)
Keep the front-left corner of your suspension tight and predictable with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly, MPN 102-7151. It installs as a direct-fit front left (driver-side) replacement for the 2010-2016 Hyundai Genesis Coupe — see the Buyer's Guide tab for the engine-level applications. Beck/Arnley builds this unit to match OE form, fit, and function so it drops in like the original and locates the wheel while allowing controlled suspension travel and steering movement.
Complete assembly: the control arm comes with the ball joint pre-installed for a single-piece installation.
Durable construction: steel, iron, or aluminum build for strength and rust/corrosion resistance.
Hardware ready: new hardware and bushings included where applicable.
Application specific: engineered for this vehicle across foreign-nameplate OE applications.
Signs the original arm or ball joint may need replacing include clunking or popping over bumps, uneven or accelerated tire wear, and loose or wandering steering. If a worn control arm or ball joint is the cause, this assembly replaces it. Sold individually; the left and right arms are separate — order the matching side you need.
It is a direct-fit front left (driver-side) replacement for the 2010-2016 Hyundai Genesis Coupe. Check the Buyer's Guide tab to confirm the engine-level application for your vehicle.
Does it include the ball joint?
Yes. The control arm comes with the ball joint pre-installed, so you get a complete single-piece assembly for installation.
What is this assembly made of?
Per Beck/Arnley, it uses steel, iron, or aluminum construction for strength and rust/corrosion resistance.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any originals may be reused.
How do I know my control arm is bad?
Clunking or popping over bumps, uneven tire wear, and loose or wandering steering can indicate a worn arm or ball joint. Diagnose the cause first; if this component is at fault, this assembly replaces it.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7151
Keep the rear suspension precisely located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8243 — the rear right upper rearward arm for the 2005-2012 Acura RL. It arrives as...
Keep the front suspension located and quiet with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-6326), a direct-fit replacement for the front right upper position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
