Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7360
$67.99
(You save)
Keep your front suspension located and aligned with the Beck/Arnley control arm and ball joint assembly 102-7360, a FRONT LEFT unit engineered to drop in as a direct replacement for the 1995-2002 Mazda Millenia. It positions the wheel, pivots on the ball joint, and lets the suspension travel while helping keep steering and alignment in check.
Complete assembly: the control arm comes with the ball joint for a complete installation.
OE form, fit and function: designed to match the original equipment's form, fit and function on the listed application.
Construction: built from steel, iron, or aluminum depending on the application, for durability and rust/corrosion resistance.
Hardware: new mounting hardware and rubber bushings are included.
Signs the original front-left arm or its ball joint may need replacing include clunking over bumps or when turning, loose or wandering steering, and uneven front tire wear. If a worn control arm or ball joint is the cause, this control arm assembly for the 1995-2002 Mazda Millenia replaces the whole unit. Have the front end diagnosed and the alignment set after installation.
What vehicle does the Beck/Arnley 102-7360 control arm fit?
It is a front-left control arm with ball joint for the 1995-2002 Mazda Millenia. See the Buyer's Guide tab to confirm the fit for your vehicle.
Does this include the ball joint?
Yes. The control arm comes with the ball joint for a complete installation.
Which position is this control arm for?
This assembly is cataloged for the FRONT LEFT position on the 1995-2002 Mazda Millenia.
What are the signs my control arm or ball joint is worn?
Common signs include clunking over bumps or when turning, loose or wandering steering, and uneven front tire wear. Diagnose the front end to confirm the cause before replacing.
Is hardware included?
Yes. New mounting hardware and rubber bushings are included. Check the service procedure for the correct fasteners and whether any originals may be reused.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7360
Replace a worn rear suspension link with the Beck/Arnley control arm 102-7552, a rear right upper arm that comes with its ball joint and connects the rear knuckle to the chassis to help keep the...
Refresh a worn 2009-2015 Honda Pilot control arm with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-7546). This control arm and ball joint assembly is application-specific...
Help keep the front wheel properly located with the Beck/Arnley control arm and ball joint assembly (P/N 102-5162). This front right lower unit drops in as a direct replacement on many vehicles,...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
