Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7691
$188.99
(You save)
Bolt the steering and ride quality back to factory spec with the Beck/Arnley control arm assembly 102-7691, a front right lower unit that installs as a direct-fit replacement on the 2002-2006 Infiniti Q45. Built with special attention to OE form, fit and function, this control arm arrives with its ball joint pre-assembled so you can replace the worn arm as one complete corner in a single job.
Complete assembly: the control arm comes with the ball joint already fitted for a one-piece installation.
Durable construction: made from steel, iron, or aluminum depending on the application for strength and rust/corrosion resistance.
Ready to install: includes new hardware and bushings where applicable.
Application specific: engineered to match OE form, fit and function for this vehicle.
If a failed arm or ball joint is behind clunking or knocking over bumps, wandering steering, or uneven front tire wear, this Infiniti Q45 control arm helps restore proper front suspension geometry when it is the cause. This listing covers the front right lower position; have your alignment checked after installation.
What vehicles does the Beck/Arnley 102-7691 control arm fit?
It is a direct-fit replacement for the 2002-2006 Infiniti Q45. See the Buyer's Guide tab to confirm the exact engine and trim for your vehicle.
Which corner is this control arm and ball joint assembly for?
It is the front right (passenger-side) lower control arm. It covers only that position, so order the matching part for the other side if needed.
Does this control arm include the ball joint?
Yes. The ball joint comes pre-assembled to the control arm for a complete, one-piece installation.
What are common signs this control arm may need replacing?
Clunking or knocking over bumps, wandering or loose steering, and uneven front tire wear can indicate a worn arm or ball joint. Diagnose the cause before replacing.
Is new hardware included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any originals may be reused.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7691
Locate the front wheel and anchor the lower suspension with the Beck/Arnley Control Arm and Ball Joint Assembly 102-8289, a G37 control arm that installs in the front left lower position on your...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
