Restore precise wheel control on your Subaru with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-7778. This front right lower unit locates the wheel and lets it move through steering and suspension travel, and it drops in as a direct-fit replacement for the 2006-2009 Subaru Legacy (see the Buyer's Guide tab for engine-level applications). The pre-assembled control arm ships with its ball joint pressed in for a complete corner in one part number.
Worn control-arm bushings or a loose ball joint can show up as clunking over bumps, uneven tire wear, or vague steering. If the original arm or its ball joint is the cause, this assembly replaces both in one step. Replacing the matching side together helps keep handling balanced.
Interchange: 62247818 · CMS80181 · 20202AG160 · 20202AG161 · 20202AG162
This part cross-references / interchanges with the following part numbers:
What vehicle does this control arm fit?
It is a direct-fit replacement for the 2006-2009 Subaru Legacy. Check the Buyer's Guide tab to confirm the engine-level application for your vehicle.
Does it include the ball joint?
Yes. The control arm comes with its ball joint already installed for a complete corner in one part number.
Which position is this assembly?
It is the front right lower control arm and ball joint assembly for the listed Subaru Legacy applications.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for correct fasteners and whether any may be reused.
What are signs this part may need replacing?
Clunking over bumps, uneven tire wear, or vague steering can point to worn bushings or a loose ball joint. Diagnose the cause before replacing.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
