Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7846
$90.99
(You save)
Keep the front suspension located and the wheel tracking true with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-7846, a front right upper control arm with the ball joint already installed. It drops in as a direct replacement designed to match OE form, fit, and function on the 2010-2011 Honda Accord Crosstour and 2012-2015 Honda Crosstour (see the Buyer's Guide tab for engine-level fitment). The arm helps support and locate the suspension while the ball joint lets the wheel move through steering and travel.
Ball joint included: the control arm ships with the ball joint for a complete installation.
OE-matched design: engineered to replace the Original Equipment part with attention to form, fit, and function.
Durable construction: built from steel, iron, or aluminum depending on the application for durability and rust/corrosion resistance.
Hardware and bushings: new hardware and bushings are included where applicable; this part is application-specific for the listed vehicles.
Signs the original may need replacing include clunking on acceleration, deceleration, or shifting, vibration, uneven tire wear, or cracked/separated bushings. Consult the vehicle service information for the correct fasteners and whether they may be reused.
It's a front right upper control arm that comes with the ball joint already installed for a complete installation. New hardware and bushings are included where applicable.
Which vehicles does part 102-7846 fit?
It's designed for the 2010-2011 Honda Accord Crosstour and 2012-2015 Honda Crosstour. Check the Buyer's Guide tab to confirm engine-level fitment for your vehicle.
What position is this control arm?
The catalog lists it as the front right upper control arm and ball joint assembly for the listed applications.
What are signs my control arm or ball joint needs replacing?
Common signs include clunking on acceleration, deceleration, or shifting, vibration, uneven tire wear, or cracked and separated bushings. Diagnose the cause before replacing.
What is this part made of?
Beck/Arnley builds it from steel, iron, or aluminum depending on the application for durability and rust/corrosion resistance. It's engineered to match OE form, fit, and function.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7846
Keep the rear suspension precisely located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8243 — the rear right upper rearward arm for the 2005-2012 Acura RL. It arrives as...
Keep the front suspension located and quiet with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-6326), a direct-fit replacement for the front right upper position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
