Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7853
$73.99
(You save)
Restore tight, predictable handling at the rear of your Mazda with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-7853 (also written 1027853). This rear upper unit locates the wheel and pivots through its integrated ball joint, and it drops in as a direct-fit replacement for the 1995-2002 Mazda Millenia. The control arm ships with its ball joint already installed for a complete installation.
Matches OE form, fit and function: engineered as a direct replacement for the original equipment on this application.
Ball joint included: the control arm comes with its ball joint for a complete, ready-to-install repair.
Durable construction: built from steel, iron, or aluminum depending on the application for strength and corrosion resistance.
New hardware and bushings included where applicable, and application-specific for this vehicle.
Worn control arm bushings or a failing ball joint can show up as clunking over the rear, uneven tire wear, or loose, wandering handling. If the original rear upper control arm or ball joint is the cause, this assembly replaces both in one piece. Consult the vehicle service information for the correct fasteners and whether they may be reused.
Interchange: T00128D00A · T00128D00B · CMS761196
This part cross-references / interchanges with the following part numbers:
T00128D00A, T00128D00B, CMS761196
Frequently Asked Questions
What vehicle does this control arm assembly fit?
It is a direct-fit replacement for the 1995-2002 Mazda Millenia. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.
Does it include the ball joint?
Yes. The control arm comes with its ball joint already installed for a complete, ready-to-install repair.
What position is this assembly for?
This is the rear upper control arm and ball joint assembly for the listed application.
Are hardware and bushings included?
New hardware and bushings are included where applicable, and the assembly is application-specific for this vehicle.
What are signs my control arm or ball joint may need replacing?
Common signs include clunking noises, uneven tire wear, and loose or wandering handling. Diagnose the cause before replacing, since these symptoms can have other sources.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7853
Keep the rear suspension precisely located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8243 — the rear right upper rearward arm for the 2005-2012 Acura RL. It arrives as...
Keep the front suspension located and quiet with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-6326), a direct-fit replacement for the front right upper position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
