Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7908
$242.99
(You save)
Tighten up steering response and restore proper wheel geometry with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-7908). It installs as a direct-fit replacement in the front left lower position on the 2012-2019 Volkswagen Beetle and the 2012-2022 Volkswagen Passat — see the Buyer's Guide tab for the engine-level details on your vehicle.
Control arm with ball joint: supplied as one assembly for a complete installation.
Matches OE form, fit and function: engineered to drop in like the original equipment part on the listed applications.
Steel, iron, or aluminum construction: built for durability and rust/corrosion resistance.
Ready to fit: includes new hardware and bushings where applicable, and is application-specific for these vehicles.
The lower control arm locates the front wheel and, through its integral ball joint, allows the knuckle to steer and travel while keeping alignment angles in check. Signs the original may need replacing include clunking on acceleration, deceleration, or over uneven pavement, loose or wandering steering, and uneven tire wear. If a worn control arm or ball joint is the cause, this assembly replaces both in one job. Replacing the matching side can help keep handling balanced.
It's a direct-fit front left lower assembly for the 2012-2019 Volkswagen Beetle and 2012-2022 Volkswagen Passat. Check the Buyer's Guide tab to confirm the exact engine for your vehicle.
Does it include the ball joint?
Yes. The control arm comes with its ball joint as a single assembly, so both are replaced together in one installation.
Is any hardware or bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any originals may be reused.
What is this control arm made of?
Per Beck/Arnley, the assembly uses steel, iron, or aluminum construction for durability and rust/corrosion resistance.
What are signs my control arm or ball joint needs replacing?
Clunking on acceleration, deceleration, or over bumps, loose or wandering steering, and uneven tire wear. Diagnose the cause first, since other parts can produce similar symptoms.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7908
Keep your front suspension located and your steering precise with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8368, cataloged for the front left lower position. It installs as...
Tighten up your Lexus's ride and restore precise wheel location with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8199. This rear left upper unit installs as a direct-fit...
Keep the rear suspension located and controlled with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-7670, a rear left upper unit that installs as a direct replacement on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
