Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7955
$190.99
(You save)
Keep the front suspension located and the steering pivot tight with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-7955. This front left (driver-side) lower control arm arrives with its ball joint pre-installed for a complete, application-specific installation on the 2014-2021 Mazda 6 and 2013-2016 Mazda CX-5. The control arm positions the front wheel and sets suspension geometry while the ball joint lets the wheel steer and travel over the road.
Direct OE replacement: Beck/Arnley engineers this assembly to match OE form, fit, and function for foreign-nameplate applications.
Ball joint included: the control arm comes with the ball joint for a complete installation.
Steel, iron, or aluminum construction for durability and rust/corrosion resistance.
New hardware and bushings included where applicable; the part is application specific for this vehicle.
Clunking or knocking over bumps, a loose or wandering feel, vibration, or uneven front tire wear can be signs the control arm or ball joint may need replacing—diagnose the cause first. This listing covers the front left lower corner; the right side uses a separate part.
What position on the vehicle does the 102-7955 fit?
It is the front left (driver-side) lower control arm and ball joint assembly for the listed Mazda applications.
Does this assembly include the ball joint?
Yes—the control arm comes with the ball joint pre-installed for a complete installation.
Are new hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any may be reused.
What vehicles does the 102-7955 fit?
It's a direct replacement for the 2014-2021 Mazda 6 and 2013-2016 Mazda CX-5. See the Buyer's Guide tab to confirm your engine and trim.
What are signs my control arm or ball joint may need replacing?
Clunking or knocking over bumps, a loose or wandering steering feel, vibration, or uneven front tire wear can be signs. Diagnose the cause before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7955
Tighten up your Lexus's ride and restore precise wheel location with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8199. This rear left upper unit installs as a direct-fit...
Keep the front suspension properly located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8103, a front right lower unit that installs as an application-specific replacement...
Restore steering precision and quiet the clunks with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-5535, also written 1025535). This front left upper control arm arrives...
Keep your front suspension properly located and your steering tight with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8380. This front right lower assembly drops in as a direct...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
