Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7957
$306.99
(You save)
Keep the left-front suspension located and the wheel under control with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-7957, a front left upper control arm that arrives with its ball joint pre-installed for a complete, one-piece replacement. It drops in as a direct-fit application for the 2015-2017 Mercedes-Benz CLS400, 2012-2018 CLS550, 2014 CLS63 AMG, 2014-2018 CLS63 AMG S, 2014-2016 E250, 2013-2016 E350, 2015-2016 E400, and 2010-2014 E550 — see the Buyer's Guide tab for engine-level detail. The control arm anchors the wheel to the chassis while the ball joint lets the assembly pivot through steering and suspension travel; worn bushings or a loose ball joint can bring on clunking over bumps, loose steering, or uneven tire wear.
OE form, fit and function: engineered as a direct replacement for the listed foreign-nameplate applications.
Complete assembly: the control arm comes with its ball joint for a complete installation.
Durable build: steel, iron, or aluminum construction for durability and rust/corrosion resistance.
Ready to install: new hardware and bushings included where applicable; application specific for this vehicle.
It is a complete control arm assembly with the ball joint pre-installed, so you replace both in one piece. New hardware and bushings are included where applicable for the listed applications.
Which position on the vehicle does this fit?
This is a front left upper control arm and ball joint assembly for the listed Mercedes-Benz applications. Confirm the position and fitment for your vehicle before ordering.
Will this fit my Mercedes-Benz?
It is a direct-fit application for the 2015-2017 CLS400, 2012-2018 CLS550, 2014 CLS63 AMG, 2014-2018 CLS63 AMG S, 2014-2016 E250, 2013-2016 E350, 2015-2016 E400, and 2010-2014 E550. Check the Buyer's Guide tab.
What are signs the control arm or ball joint may need replacing?
Clunking or knocking over bumps, loose or wandering steering, and uneven tire wear can be signs of worn bushings or a failing ball joint. Diagnose the cause before replacing.
What is it made of?
Depending on the application, it uses steel, iron, or aluminum construction chosen for durability and rust/corrosion resistance. It is designed to match OE form, fit and function.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7957
Keep the rear suspension precisely located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8243 — the rear right upper rearward arm for the 2005-2012 Acura RL. It arrives as...
Keep the front suspension located and quiet with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-6326), a direct-fit replacement for the front right upper position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
