Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8034
$60.99
(You save)
Keep your Honda Pilot control arm geometry tight and your rear suspension located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8034. This rear left upper unit installs as a direct-fit, application-specific replacement for the 2009-2013 Acura MDX and 2009-2015 Honda Pilot (see the Buyer's Guide tab for engine specifics).
Matches OE form, fit and function — a direct replacement built to Beck/Arnley requirements and specifications for foreign-nameplate applications.
Ball joint included — the control arm comes with its ball joint for a complete installation.
Steel, iron, or aluminum construction for durability and rust/corrosion resistance.
New hardware and bushings included where applicable.
The control arm locates the wheel and lets the suspension travel while the integrated ball joint provides the pivoting connection to the steering knuckle. If a worn arm or ball joint is behind clunking over bumps, wandering steering, or uneven tire wear, this assembly replaces the failed original. As an Acura Mdx control arm and BECK ARNLEY control arm option, it's application specific for these vehicles.
Will this fit my 2009 Honda Pilot control arm replacement?
Yes. The 102-8034 assembly is listed for the 2009-2015 Honda Pilot and the 2009-2013 Acura MDX. Check the Buyer's Guide tab to confirm your exact vehicle and engine.
What position does this Acura Mdx control arm cover?
It is the rear left upper control arm and ball joint assembly for the listed applications.
Does this control arm and ball joint assembly come with the ball joint?
Yes. The control arm ships with its ball joint for a complete installation, and new hardware and bushings are included where applicable.
What is this BECK ARNLEY control arm made of?
Beck/Arnley builds it with steel, iron, or aluminum construction for durability and rust/corrosion resistance, matching OE form, fit and function.
What are the signs this control arm or ball joint may need replacing?
Clunking over bumps, wandering steering, or uneven tire wear can point to a worn arm or ball joint. Have the cause diagnosed, and if this component is at fault, replace it.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8034
Locate the front wheel and anchor the lower suspension with the Beck/Arnley Control Arm and Ball Joint Assembly 102-8289, a G37 control arm that installs in the front left lower position on your...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
