Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8092
$260.99
(You save)
Restore steering precision and tame worn-suspension wander with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-8092), a direct-fit Honda Pilot control arm for the front right lower position. It drops in as an application-specific replacement for the 2016-2022 Honda Pilot and 2014-2020 Acura MDX (see the Buyer's Guide tab for engine coverage), locating the wheel and hub while the integrated ball joint lets the knuckle pivot as you steer and the suspension cycles.
Ball joint pre-installed: the control arm comes with its ball joint for a complete installation.
Bushings included: pre-fitted bushings; mounting hardware is not included — consult the vehicle service information for the correct fasteners and whether they may be reused.
Aluminum construction: for light weight and corrosion resistance.
Matches OE form, fit and function: engineered as a direct replacement for the listed applications.
Signs this front lower control arm assembly may need replacing include clunking on acceleration or over uneven pavement, loose or wandering steering, uneven tire wear, and a rattle from the front suspension traced to a worn arm bushing or ball joint. If a failed control arm or ball joint is the cause, this assembly replaces both in one part.
Will this fit my Honda Pilot lower control arm position?
Yes — it's the front right lower control arm and ball joint assembly for the 2016-2022 Honda Pilot. Confirm your position and fitment in the Buyer's Guide tab.
Does it fit a 2016 Honda Pilot lower control arm application?
Yes, the 2016 Honda Pilot is within the covered 2016-2022 range for this front right lower assembly.
Is this also an Acura Mdx control arm?
Yes. This Beck/Arnley assembly is listed for the 2014-2020 Acura MDX as well as the 2016-2022 Honda Pilot.
Does the ball joint and bushings come with it?
The control arm comes with the ball joint pre-installed and includes bushings. Mounting hardware is not included.
What is this part made of?
It uses aluminum construction for light weight and corrosion resistance, and is engineered to match OE form, fit and function for the listed applications.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8092
Keep the front wheel precisely located and free to pivot through steering and suspension travel with the Beck/Arnley control arm 102-6654, engineered to drop in like the original front left lower arm...
Support the front suspension and keep the wheel located with the Beck/Arnley Control Arm and Ball Joint Assembly (MPN 102-6320), a direct-fit front right lower Nissan Frontier control arm for the...
Replace a worn Hyundai Sonata control arm with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-6070, a front right upper control arm and ball joint assembly built as a direct...
Restore steady, controlled handling with the Beck/Arnley Control Arm with Ball Joint 102-7135, a front lower vw Passat control arm that also serves a range of Audi models. It drops in as a direct...
Steady the front end and keep steering response tight with the Beck/Arnley control arm and ball joint assembly (P/N 102-7072). This front left lower unit drops in as a direct-fit replacement for the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
