Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8156
$153.99
(You save)
Restore precise front-end geometry and tight steering with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8156 (also written 1028156). This is the front left lower assembly, and it drops in as a direct-fit replacement for the 2016-2021 Honda Civic and 2019-2022 Honda Insight — see the Buyer's Guide tab for engine-level fitment on your vehicle.
Complete assembly: the control arm comes with the ball joint pre-installed for a one-piece installation.
OE form, fit and function: engineered as a direct replacement for Original Equipment applications across foreign nameplates, with attention to form, fit and function.
Durable construction: built from steel, iron, or aluminum depending on the application for durability and rust/corrosion resistance.
Application specific: new hardware and bushings are included where applicable for this vehicle.
The lower control arm locates the wheel and, through its integrated ball joint, allows the steering knuckle to pivot while the bushings absorb road inputs. Signs this part may need replacing include clunking on acceleration or over bumps, uneven tire wear, or loose, wandering steering — diagnose the cause before replacing. Consult the vehicle service information for the correct fasteners and whether they may be reused.
It fits the 2016-2021 Honda Civic and 2019-2022 Honda Insight. Check the Buyer's Guide tab to confirm the correct engine and trim for your vehicle.
Which position is this assembly for?
This is the front left (driver's side) lower control arm and ball joint assembly for the listed applications.
Does it come with the ball joint installed?
Yes. The control arm comes with the ball joint pre-installed as a complete one-piece assembly, so you install both together.
What is this part made of?
Depending on the application, it is built from steel, iron, or aluminum for durability and rust/corrosion resistance.
Are mounting fasteners included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any may be reused.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8156
Keep your front suspension located and your steering precise with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8368, cataloged for the front left lower position. It installs as...
Tighten up your Lexus's ride and restore precise wheel location with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8199. This rear left upper unit installs as a direct-fit...
Keep the rear suspension located and controlled with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-7670, a rear left upper unit that installs as a direct replacement on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
