Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8161
$175.99
(You save)
Keep the rear suspension of your LS430 control arm setup properly located with the Beck/Arnley Control Arm and Ball Joint Assembly, MPN 102-8161. It drops in as a direct-fit replacement for the 2001-2006 Lexus LS430 in the rear right upper position, pairing the arm and its ball joint in one unit so you can locate the rear suspension and help maintain a precise steering feel. Beck/Arnley builds this Beck/Arnley control arm to match OE form, fit and function for foreign-nameplate applications.
Complete assembly: the control arm comes with the ball joint already fitted for a complete installation.
OE-matched: engineered to match OE form, fit and function.
Durable construction: built from steel, iron, or aluminum for durability and rust/corrosion resistance.
Ready to install: new hardware and bushings included where applicable; application-specific for this vehicle.
Worn control-arm bushings or a loose ball joint can show up as clunking over bumps, wandering or loose steering, uneven tire wear, and vibration. If the original rear right upper arm or its ball joint is the cause, this LS430 rear upper control arm replaces it.
What vehicle does this LS430 rear control arm fit?
It is a direct-fit replacement for the 2001-2006 Lexus LS430, in the rear right upper position. Check the Buyer's Guide tab to confirm it matches your vehicle.
Does the ball joint come with this control arm?
Yes. This is a control arm and ball joint assembly, so the arm ships with its ball joint already fitted for a complete installation.
What is this assembly made from?
It is built from steel, iron, or aluminum construction for durability and rust/corrosion resistance, engineered to match OE form, fit and function.
Are new bushings and hardware included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any originals may be reused.
What are signs this control arm may need replacing?
Clunking over bumps, loose or wandering steering, uneven tire wear, and vibration can point to worn bushings or a loose ball joint. Diagnose the cause before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8161
Keep the front wheel precisely located and free to pivot through steering and suspension travel with the Beck/Arnley control arm 102-6654, engineered to drop in like the original front left lower arm...
Support the front suspension and keep the wheel located with the Beck/Arnley Control Arm and Ball Joint Assembly (MPN 102-6320), a direct-fit front right lower Nissan Frontier control arm for the...
Replace a worn Hyundai Sonata control arm with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-6070, a front right upper control arm and ball joint assembly built as a direct...
Restore steady, controlled handling with the Beck/Arnley Control Arm with Ball Joint 102-7135, a front lower vw Passat control arm that also serves a range of Audi models. It drops in as a direct...
Steady the front end and keep steering response tight with the Beck/Arnley control arm and ball joint assembly (P/N 102-7072). This front left lower unit drops in as a direct-fit replacement for the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
