Tighten up your front end and quiet worn-joint clunks with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8210. This front left lower assembly is an application-specific, direct-fit replacement for the 2015-2021 Kia Sedona — see the Buyer's Guide tab for the full engine-level fitment. It locates the front left lower suspension, allows controlled wheel travel, and carries a pre-assembled ball joint so you can swap the arm and joint in one step.
If a failed arm or a worn ball joint is behind clunking over the front left, wandering steering, or uneven tire wear, this assembly replaces those components. Follow the service procedure for correct fasteners and torque, and have the alignment checked after installation.
Interchange: 2703582835 · 54500A9100 · 54500A9200 · RK623867 · CMS901249
This part cross-references / interchanges with the following part numbers:
What vehicles does the 102-8210 fit?
It is an application-specific, direct-fit replacement for the 2015-2021 Kia Sedona. Check the Buyer's Guide tab to confirm the engine-level fitment for your exact vehicle.
Does this control arm include the ball joint?
Yes. The ball joint comes pre-installed in the control arm, so you replace both as one complete assembly in a single step.
What position is this assembly for?
It is the front left lower control arm and ball joint assembly for the listed Kia Sedona applications.
What is it made of?
Per Beck/Arnley, the assembly uses steel, iron, or aluminum construction selected for strength and rust/corrosion resistance.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners, torque, and whether any originals may be reused.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
