Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8211
$160.99
(You save)
Steer out the play in your steering and suspension with the Beck/Arnley control arm 102-8211, a front right lower Suspension Control Arm and Ball Joint Assembly built as a direct-fit replacement for the 2015-2021 Kia Sedona. The control arm ships with its ball joint pre-installed for a complete, single-unit installation, so the pivot and load-bearing joint are replaced together on the front right lower corner.
Matched to OE: engineered to reproduce the original part's form, fit and function on the listed application.
Complete assembly: the control arm comes with the ball joint for a one-piece install.
Durable construction: steel, iron, or aluminum build for strength and rust/corrosion resistance.
Hardware & bushings: new hardware and bushings included where applicable.
This is an application-specific part designed for the front right lower position. If a worn control-arm bushing or a loose lower ball joint is the cause of clunking over the road, uneven tire wear, or wandering steering, this assembly replaces both in one step. Consult the vehicle service information for the correct fasteners and torque, and whether any originals may be reused.
What vehicle does the Beck/Arnley 102-8211 control arm fit?
It is a direct-fit replacement for the 2015-2021 Kia Sedona. See the Buyer's Guide tab to confirm your exact trim and engine before ordering.
Is this a front right lower control arm and ball joint assembly?
Yes. This unit is cataloged for the front right lower position and comes as a control arm and ball joint assembly for that corner.
Does the ball joint come installed on the control arm?
Yes. The control arm ships with its ball joint pre-installed, so you replace both the pivot bushings and the ball joint in one complete piece.
What is this control arm made of?
Beck/Arnley builds it in steel, iron, or aluminum construction for strength and rust/corrosion resistance. It is matched to the original part's form, fit and function.
Are mounting hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners, torque, and whether any originals may be reused.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8211
Locate the front wheel and anchor the lower suspension with the Beck/Arnley Control Arm and Ball Joint Assembly 102-8289, a G37 control arm that installs in the front left lower position on your...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
