Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8222
$202.99
(You save)
Keep your Lexus tracking straight and quiet with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8222 (also written 1028222). This is the front left lower rearward control arm, and it arrives with the ball joint pre-installed for a complete corner replacement. It's a direct-fit for the 2009-2012 Lexus LS460 and the 2008-2016 Lexus LS600H — see the Buyer's Guide tab for engine-level fitment.
Control arm + ball joint: the arm comes with its ball joint for a complete installation on the listed applications.
OE-matched: built to match OE form, fit, and function as a direct replacement.
Durable construction: steel, iron, or aluminum construction for durability and rust/corrosion resistance.
Hardware & bushings: new hardware and bushings included where applicable.
The control arm locates the wheel and, through its integrated ball joint, allows the steering and suspension to move while holding proper alignment. Signs this part may need replacing include clunking on acceleration, deceleration, or over bumps, wandering steering, uneven tire wear, or play in the joint. This is an application-specific part for this vehicle. Replacing the matching arm on the opposite side is a good practice for balanced handling.
This part cross-references / interchanges with the following part numbers:
2703288363, 4867059015, 4867059016, WP539337OES
Frequently Asked Questions
Does this control arm come with the ball joint?
Yes. The ball joint comes pre-installed with the control arm for a complete corner installation on the listed applications.
Which vehicles does the 102-8222 fit?
It's a direct-fit for the 2009-2012 Lexus LS460 and the 2008-2016 Lexus LS600H. Check the Buyer's Guide tab for engine-level fitment.
What position is this control arm?
It is the front left lower rearward control arm assembly for the listed Lexus applications.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Review the service procedure for the correct fasteners and torque before installing.
How do I know if my control arm or ball joint is worn?
Common signs include clunking on acceleration, deceleration, or over bumps, wandering steering, uneven tire wear, or play in the joint. Diagnose the cause before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8222
Restore tight, precise steering and wheel control with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8213, a front right lower unit that locates the wheel and pivots through its...
Restore precise steering and a quiet, controlled ride with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (MPN 102-6554). This front left lower control arm arrives with the ball joint...
Keep the front-right wheel located and steering true with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8278. This is the front right lower control arm with its ball joint...
Restore precise steering geometry and quiet the clunks of a worn suspension joint with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-6142. This is a front right lower unit that...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
