Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8319
$223.99
(You save)
Restore precise wheel location and tighten up steering feel with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly, MPN 102-8319. It drops in as a direct-fit replacement for the 2019-2020 Hyundai Santa Fe (see the Buyer's Guide tab for engine-level fitment) in the front left lower position. The control arm locates the front suspension and connects to the steering knuckle through its integrated ball joint, allowing the suspension to travel while keeping the wheel properly aligned.
Ball joint included: the control arm ships with its ball joint for a complete installation.
OE form, fit and function: engineered to match the original component on the listed application.
Steel, iron, or aluminum construction: built for durability with rust and corrosion resistance.
Hardware and bushings: new hardware and bushings are included where applicable.
Signs the original arm or ball joint may need replacing include clunking over the front, loose or wandering steering, and uneven front tire wear. Because it locates the wheel, replacing a worn unit helps support and position the front suspension. This is an application-specific part for the vehicle listed above.
Interchange: 2703709200 · 54500S1050 · CMS901278
This part cross-references / interchanges with the following part numbers:
2703709200, 54500S1050, CMS901278
Frequently Asked Questions
What vehicle does this control arm assembly fit?
It is a direct-fit replacement for the 2019-2020 Hyundai Santa Fe. Check the Buyer's Guide tab to confirm engine-level fitment for your vehicle.
What position is this part for?
This assembly is cataloged for the front left lower position. Order the correct side and position for your vehicle.
Does it come with the ball joint?
Yes. The control arm ships with its ball joint already installed for a complete installation.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any may be reused.
What are signs my control arm or ball joint is worn?
Common signs include clunking over bumps at the front, loose or wandering steering, and uneven front tire wear. Have the cause diagnosed before replacing.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8319
Keep your front suspension located and your steering precise with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8368, cataloged for the front left lower position. It installs as...
Tighten up your Lexus's ride and restore precise wheel location with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8199. This rear left upper unit installs as a direct-fit...
Keep the rear suspension located and controlled with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-7670, a rear left upper unit that installs as a direct replacement on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
