Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8348
$100.99
(You save)
Tighten up the front left lower corner of your suspension with the Beck/Arnley control arm and ball joint assembly (P/N 102-8348), a direct-fit replacement for the 2016 Scion iA, 2019-2020 Toyota Yaris, and 2017-2018 Toyota Yaris iA. This front left lower unit locates the wheel and pivots on its integrated ball joint, helping hold your alignment geometry and steady the ride.
OE form, fit and function: engineered to match the original equipment part for a confident, straightforward install.
Complete assembly: the control arm ships with its ball joint already fitted, so you replace both wear points in one step.
Steel, iron, or aluminum construction: chosen for durability and rust/corrosion resistance.
Hardware and bushings: new hardware and bushings are included where applicable.
If a worn ball joint or failing bushing in this Toyota Yaris lower arm is behind clunks over bumps, loose steering, or uneven front tire wear, this Toyota Yaris front suspension arm replaces the whole assembly at once. Consult the vehicle service information for the correct fasteners and whether they may be reused.
It is a direct-fit replacement for the 2016 Scion iA, 2019-2020 Toyota Yaris, and 2017-2018 Toyota Yaris iA. See the Buyer's Guide tab for engine-level details.
Does the control arm come with a ball joint?
Yes. This control arm and ball joint assembly ships with the ball joint already fitted, so you replace both wear points in a single installation.
What position is this control arm for?
It is the front left (driver's side) lower control arm for the listed applications.
What are signs this part may need replacing?
Clunking over bumps, loose or wandering steering, and uneven front tire wear can point to a worn control arm bushing or ball joint. Diagnose the cause before replacing.
Is mounting hardware included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any originals may be reused.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-8348
Tighten up a loose, clunky front end with the Beck/Arnley control arm and ball joint assembly, MPN 102-8406 — a direct-fit replacement for the 2017-2024 Tesla 3. It installs in the front lower...
Keep the rear suspension of your LS430 control arm setup properly located with the Beck/Arnley Control Arm and Ball Joint Assembly, MPN 102-8161. It drops in as a direct-fit replacement for the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
