Beck/Arnley Suspension Control Arm P/N:102-6596
Steady your ride with the Beck/Arnley control arm (P/N 102-8340), a rear right upper rearward suspension arm built as a direct replacement for the 2015-2021 Kia Sedona. It locates the wheel and pivots on its bushings to keep suspension geometry in check, and it's engineered to match OE form, fit and function so it drops onto the listed application without guesswork.
Worn control arms and bushings can show up as clunking or knocking over bumps, uneven tire wear, and loose or wandering steering. If a failed rear right upper rearward arm is behind those signs on your Kia Sedona control arm setup, this replaces it. Because rear suspension arms work as a matched set side to side, have an alignment performed after installation.
Interchange: 55100A9000 · 55101A9000
This part cross-references / interchanges with the following part numbers:
What vehicle does the Beck/Arnley 102-8340 control arm fit?
It is a direct-fit replacement for the 2015-2021 Kia Sedona. Check the Buyer's Guide tab to confirm it matches your exact trim and engine.
Which position is this control arm?
This is the rear right upper rearward control arm for the listed application.
Does this control arm include a ball joint?
No. Per the OE design, this control arm comes without a ball joint.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any originals may be reused.
Should I replace both sides at once?
Rear suspension arms work as a matched set side to side, so inspect both. Have an alignment performed after installing this part.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.