Beck/Arnley Suspension Control Arm P/N:102-6596
Keep the front suspension located and under control with the Beck/Arnley Suspension Control Arm 102-8387, a front right lower control arm that drops in as a direct-fit replacement for the 2018-2022 Honda Accord. It anchors the wheel assembly to the chassis, pivots on its bushings to allow suspension travel, and helps hold the wheel in its intended alignment for stable, controlled handling.
Worn control-arm bushings or a loose joint can show up as clunking or knocking over bumps, steering wander, and uneven tire wear. If a failing front right lower control arm is the cause, this unit replaces it. Refer to the Buyer's Guide tab for engine-level fitment details.
Interchange: MS601269 · 2703667982 · 51350TVAA04 · RK623748 · CMS601269 · WP1889747OES
This part cross-references / interchanges with the following part numbers:
What vehicle does this control arm fit?
It's a direct-fit replacement for the 2018-2022 Honda Accord in the front right lower position. See the Buyer's Guide tab for engine-level fitment details.
Does this control arm include a ball joint?
No. It comes without a ball joint, which matches the OE design for this application.
What is the control arm made of?
It uses steel, iron, or aluminum construction for durability and rust/corrosion resistance.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether they may be reused.
What are signs the control arm may need replacing?
Clunking or knocking over bumps, steering wander, and uneven tire wear can point to worn control-arm bushings or joints. Diagnose the cause before replacing.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.