Keep the rear suspension precisely located and aligned with the Beck/Arnley Suspension Control Arm 102-8421. It installs as a direct-fit replacement in the rear right upper rearward position on the 2008-2022 Toyota Sequoia. The control arm links the suspension to the chassis, positions the wheel, and pivots on its bushings to allow suspension travel while helping maintain proper alignment.
Worn control arms or bushings can show up as clunking or knocking over bumps, wandering steering, uneven tire wear, or an alignment that won't hold. If a failed control arm or its bushings are the cause, this replaces the original in the rear right upper rearward position.
Interchange: RK642493 · 487700C010
This part cross-references / interchanges with the following part numbers:
What vehicle does this control arm fit?
It is a direct-fit replacement for the 2008-2022 Toyota Sequoia. See the Buyer's Guide tab to confirm the exact fit for your vehicle.
Where is this control arm located?
The catalog lists it for the rear right upper rearward position on the listed Sequoia application.
Does it include a ball joint?
No. This control arm comes without a ball joint, which matches the OE design.
Are hardware and bushings included?
New hardware and bushings are included where applicable for this application.
What are signs my control arm may need replacing?
Clunking or knocking over bumps, wandering steering, uneven tire wear, or an alignment that won't hold can indicate a worn control arm or bushings. Diagnose the cause before replacing.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
