Quiet the rattles and keep your rear sway bar located with the Beck/Arnley Suspension Stabilizer Bar Bushing Kit 101-7565. These rear stabilizer bar bushings cushion and locate the rear anti-roll bar, isolating it from the mounting brackets so the bar can control body lean while damping road-borne noise. This kit installs as a direct-fit replacement for the 2011-2015 Hyundai Sonata and 2011-2013 Kia Optima — see the Buyer's Guide tab for engine-level details.
Worn or cracked stabilizer bar bushings may show up as a clunk or rattle over uneven pavement, increased body roll, or looseness in the rear sway bar. If deteriorated bushings are the cause, these replace them to restore proper bar location. Inspect and replace both sides together for balanced handling.
Interchange: 8400583 · 555133S000
This part cross-references / interchanges with the following part numbers:
What vehicles does this bushing kit fit?
It fits the 2011-2015 Hyundai Sonata and 2011-2013 Kia Optima. Check the Buyer's Guide tab to confirm the correct application for your vehicle.
Is this for the front or rear stabilizer bar?
This kit is cataloged for the REAR stabilizer bar. It cushions and locates the rear anti-roll bar in its mounting brackets.
What are these bushings made from?
They are molded from a high-grade rubber compound that resists heat, wear, salt, road grime, and oils for durable service.
What are signs the stabilizer bar bushings need replacing?
Common signs include a clunk or rattle over bumps, increased body roll, or a loose-feeling sway bar. Diagnose the cause before replacing.
Should I replace both sides at once?
Yes, replacing the bushings on both sides together is recommended for even, balanced handling. Inspect related hardware during installation.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
