Beck/Arnley Suspension Stabilizer Bar Bushing Kit P/N:101-8317
$13.99
(You save)
Quiet the clunks and keep the rear sway bar located with the Beck/Arnley Sway Bar Bushing Kit (P/N 101-8317). This stabilizer bar bushing kit drops in as a direct-fit replacement for the rear stabilizer bar on the 2001-2005 Toyota RAV4. The bushings cushion the stabilizer (sway) bar where it clamps to the chassis, helping control body roll and keep the bar located as the suspension works.
OE form, fit and function: engineered to replace the original equipment bushings on this application.
Built to endure: resistant to heat, wear, salt, road grime, and oils.
High-grade rubber compound: molded for durable, quality construction.
Application specific: matched to this vehicle for a confident install.
Over time worn or cracked sway bar bushings can allow extra movement, and if deteriorated bushings are the cause of a rear clunk over bumps, body roll in corners, or rubber squeak, this kit replaces them. Beck/Arnley sources OE-quality foreign-nameplate parts through a trusted global network. Inspect both sides and replace as a set for balanced handling.
This part cross-references / interchanges with the following part numbers:
37751011001, K201431, 4881542040, W01331809071
Frequently Asked Questions
What vehicle does the Beck/Arnley 101-8317 kit fit?
It is a direct-fit replacement for the rear stabilizer bar bushings on the 2001-2005 Toyota RAV4. See the Buyer's Guide tab to confirm your exact vehicle.
What does a sway bar bushing do?
It cushions the stabilizer (sway) bar where it mounts to the chassis, helping control body roll and keeping the bar located as the suspension moves.
What are signs the bushings may need replacing?
Cracked or worn rubber, a clunk or knock over bumps, increased body roll in corners, or a rubber squeak. Diagnose the cause before replacing.
What are the bushings made of?
They are made from a high-grade rubber compound and are resistant to heat, wear, salt, road grime, and oils for durability.
Should I replace both sides at once?
Yes, replacing the bushings on both sides together is recommended so the rear stabilizer bar is supported evenly for balanced handling.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Stabilizer Bar Bushing Kit P/N:101-8317
Quiet the clunks and keep your Subaru's stabilizer bar located with the Beck/Arnley Suspension Stabilizer Bar Bushing Kit 101-8306 (also written 1018306). These rear stabilizer bar bushings cradle...
Quiet a clunking, loose-feeling front sway bar with the Beck/Arnley Suspension Stabilizer Bar Bushing Kit 101-7996 (also written 1017996). This front stabilizer bar bushing kit cushions the bar where...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
