Bosch ABS Wheel Speed Sensor P/N:0986594545
Keep your ABS and stability control reading wheel rotation accurately with the Bosch ABS Wheel Speed Sensor 0265009338. This rear-left sensor is a direct OE fit for the 2010-2018 Mercedes-Benz Sprinter 2500 (All engines), detecting wheel speed and feeding that signal to safety systems like ABS and ESP.
As a key component of ABS and ESP, the wheel speed sensor is factory tested and designed with occupant and pedestrian safety in focus. It has one female round connector with two male pin terminals and an integrated wiring harness roughly 1886 mm (74.25 in) long, for simple, hassle-free installation. If a failed rear-left wheel speed sensor is the cause of an ABS or traction-control warning light, this Bosch unit replaces it. Country of origin: Romania.
Interchange: 9065400117
This part cross-references / interchanges with the following part numbers:
Will this sensor fit my vehicle?
It is a direct-fit rear-left ABS wheel speed sensor for the 2010-2018 Mercedes-Benz Sprinter 2500 (All engines). Check the Buyer's Guide tab to confirm it matches your vehicle.
What does an ABS wheel speed sensor do?
It detects the wheel's rotational speed and sends that signal to the ABS/ESP system, which continuously monitors for wheel slip under conditions like snow, ice, and rain.
What are signs this sensor may need replacing?
An illuminated ABS, traction control, or ESP warning light, or those systems dropping out, can be signs. Have the fault diagnosed first, since other causes are possible.
What number does this sensor replace?
It cross-references OE/interchange number 9065400117.
What connector and harness does it have?
It has one female round connector with two male pin terminals and an integrated wiring harness approximately 1886 mm (74.25 in) long.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.