Bosch 69695 fuel pump and strainer set for the 1987-1993 BMW 325i 6-cylinder 2.5L and other vehicles pumps gasoline from the tank to the fuel injection system. This electric, self-priming Bosch fuel pump sits inside the tank and is built and tested to the same OE quality standards as the brand's own OE pumps.
- Bosch fuel pump with a service life tested to a minimum of 150k miles
- Patented Turbine Pump design that virtually eliminates fuel pulsation, noise and hot-start problems of older pump designs
- Designed to operate in extreme temperatures and under low fuel conditions
- Electromagnetic shielding that prevents on-board electronic interference from the pump
- Every pump is function tested at the end of the line
- Carbon commutators of a special graphite compound reduce armature wear and resist the effects of ethanol
Quick facts
- Part: Bosch 69695 fuel pump and strainer set
- Fits: 1987-1993 BMW 325i 6-cylinder 2.5L and other vehicles
- Material: Mixed
- Condition: New
Hard starting, sputtering under load or stalling can point to a worn pump, but a clogged fuel filter or a failing fuel pressure regulator can also be behind them, so track down the cause first.
Fits
As an in-tank pump and strainer set, it is a direct-fit replacement for the 1988-1991 BMW 325is 6-cylinder 2.5L and the 1988-1991 BMW 325iX 6-cylinder 2.5L, besides the car named above. If your BMW is not one of these, look up its year and engine on the Buyer's Guide tab.
Specifications
Fit and size
- Quantity per vehicle: 1
- Inlet size: 11.1 mm
- Outlet size: 11.1 mm
- Housing width: 36 mm
- Terminals: 2
Build and materials
- Type: electric, in-tank, self-priming, pump only
- Voltage: 12 V
- Fuel type: gas
- Material: mixed
- Housing material: metal
- Strainer attachment: push on
- Condition: new
In the box
One fuel pump and strainer set with an O-ring. The listing holds one set, which covers one vehicle. Gaskets, a lock ring, mounting hardware, a wire harness, a fuel sending unit and a suction pipe are not included, so plan on new mounting hardware and a lock ring, as the old ones may not be reusable.
Installation notes
- Designed for simple plug-and-play installation.
- The strainer attaches with a push-on fit.
Interchange: 16141184022
