Raybestos Brakes Disc Brake Caliper P/N:FRC11396
Replace a worn or leaking rear right caliper with the Raybestos R-Line FRC11961, a remanufactured, semi-loaded caliper and bracket assembly that clamps the brake pads against the rotor when you press the pedal. It fits many vehicles, among them the 2007-2017 Jeep Compass, 2007-2017 Jeep Patriot and 2008-2014 Dodge Avenger, all engines. See the Buyer's Guide tab for the full list.
This non-plated R-Line disc brake caliper is a remanufactured OE part rebuilt with all-new rubber and sealing components. Castings, guide pins and brackets are carefully inspected before they are reused, and each caliper is rigorously tested for reliable braking.
Specifications: floating-type caliper with a cast iron casting; 1.374 in (34.9 mm) piston diameter; M7x1 bleeder screw thread; 10 mm bracket mounting holes with a 1.25 mm thread pitch. Country of origin: Mexico.
This listing is for one rear right caliper and bracket assembly, and the listed applications use one in that position. Replacing the left and right rear calipers together is recommended for even, balanced braking.
Interchange: 99-17729A · 18-B5038 · 18-P5038 · 141.63533 · 10-1269S · 14-1269
9917729A · 18B5038 · 18P5038 · 14163533 · 101269S · 141269 · SC0210
This part cross-references / interchanges with the following part numbers:
Will this work as a rear right Jeep Compass brake caliper?
Yes. FRC11961 is listed as a rear right caliper and bracket assembly for the 2007-2017 Jeep Compass, all engines. Check the Buyer's Guide tab to confirm your exact vehicle.
Does it also fit as a Jeep Patriot brake caliper?
Yes. It is listed for the rear right position on the 2007-2017 Jeep Patriot and the 2008-2014 Dodge Avenger, all engines. The Buyer's Guide tab shows every application.
Which components are replaced with new parts during remanufacturing?
Seals, boots, bleeder screws, abutment hardware, banjo bolts and O-rings are all new. Castings, guide pins and brackets are inspected before reuse, and each unit is 100% pressure tested.
What are the key specifications?
It is a floating-type caliper with a cast iron casting, a 1.374 in (34.9 mm) piston diameter, an M7x1 bleeder screw thread, and 10 mm bracket mounting holes with a 1.25 mm thread pitch.
What signs suggest a brake caliper may need replacing?
Possible signs include brake fluid leaking at the caliper, a brake that drags or pulls to one side, or uneven pad wear. Diagnose the cause first. If the caliper is at fault, this assembly replaces it.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.