CARDONE New CV Axle Assembly P/N:66-8152
CARDONE New 66-2004 front left CV axle for the 1986-1990 Ford Escort and other vehicles carries drive torque from the transaxle to the wheel. This CV axle assembly has CV joints at both ends, so the wheel can steer and follow the suspension while it keeps turning.
A clicking or snapping noise when you turn hard under power, a vibration when you accelerate, or grease on the chassis and suspension from a split boot can mean the axle is worn. Before you replace this axle, rule out a broken engine mount or its hardware, which can let the drivetrain shift and bind the inner joint.
This axle is listed for a wide range of Ford and Mercury models, including the 1984-1990 Ford Tempo and the 1984-1990 Mercury Topaz. If your car is not named here, look up its year and model in the "Vehicles it fits" section on this page. The 1986-1990 Ford Escort takes one on this side; the front right is its own part, ordered separately.
Fit and size
Build and materials
One complete CV axle with its CV joints, a new hex axle retaining nut and an instruction sheet. The ABS tone ring is not included.
Interchange: E3FZ3B436H · E43Z3B436D · E4FZ3B414A · F03Z3V427BARM
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this 1986-1990 Ford Escort CV axle the front left one?
Yes. CARDONE New 66-2004 is the front left CV axle for the 1986-1990 Ford Escort, and it also fits the 1984-1990 Ford Tempo. The front right is a separate part.
Does the CARDONE 66-2004 come with a new axle nut?
Yes. CARDONE 66-2004 comes with a new hex axle retaining nut (M20x1.5 thread) and an instruction sheet. The ABS tone ring is not included.
What socket size does the axle nut on this CV axle take?
The hex axle nut takes a 29 mm (1.142 in) socket. Tighten it with a torque wrench to the vehicle maker's specification, not an impact wrench.
What can a clicking noise when turning hard mean on a CV axle?
Clicking or snapping when you turn hard under power can mean a worn outer joint. Grease on the chassis can mean a split boot. A shop can confirm which.
Do I need new transaxle seals when installing this CV axle?
Yes. Install new transaxle seals when replacing a CV axle, to avoid leaks. The old axle nut is discarded too, because a new retaining nut comes with the axle.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.