CARDONE New CV Axle Assembly P/N:66-1508
CARDONE New 66-2059 front left CV axle for the 1999-2002 Mercury Cougar and other vehicles carries drive torque from the transmission to the front left wheel. This new CV axle assembly comes with its CV joints.
Clicking when you turn under power, grease on the chassis or suspension, or vibration on acceleration can mean the axle is worn, though a broken engine mount or a worn hub bearing can be behind some of them. Consider replacing both front axles together; this listing is one axle.
The 1999-2002 Mercury Cougar, the 1995-2000 Ford Contour and the 1995-2000 Ford Mystique are among the vehicles it fits. Each takes one on the front left side, and the front right axle is a separate part. If your car is not named here, look it up in the "Vehicles it fits" section. The axle is engineered to OE form, fit and function.
Fit and size
Build and materials
One complete front left CV axle and one instruction sheet.
Interchange: F5RZ3V427EARM · F5RZ3V427FARM · F8RZ3B437DD
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the CARDONE 66-2059 CV axle right for a 1995-2000 Ford Contour?
Yes. This CARDONE New 66-2059 is a front left CV axle for the 1995-2000 Ford Contour, and the front right side is a separate part. Look up other cars in the "Vehicles it fits" section.
Does this CV axle come with a new axle nut?
Yes. A new hex axle nut with an M22x1.5 thread comes with the axle, along with an instruction sheet.
What shaft diameter and spline counts does the 66-2059 axle have?
This CARDONE 66-2059 has a 27 mm (1.063 in) shaft, with 35 splines on the inboard end and 27 splines on the outboard end.
Why did my ABS light come on after I installed a new CV axle?
A sensor ring, sensor or sensor wiring near the axle may have been damaged during installation, sending the ABS module an erratic speed signal. This axle includes a 44-tooth window-type ABS tone ring.
Can I use an impact wrench to tighten the axle nut?
No. Use a torque wrench and tighten the nut on this front left CV axle to the manufacturer's specification, never an impact wrench.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.