Front Left Brake Caliper for 1968-1973 Ford Mustang & More - CARDONE Reman 18-4013

Be the first to review this product
$98.99
MPN: 18-4013
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

CARDONE Reman Disc Brake Caliper P/N:18-4013
CARDONE Reman Disc Brake Caliper P/N:18-4013
$98.99

Keep the front left brake clamping as designed with the A1 CARDONE Remanufactured Unloaded Disc Brake Caliper 18-4013, a direct-fit A1 CARDONE brake caliper that presses the pads against the rotor under hydraulic pressure. It fits many vehicles, among them the 1968-1973 Ford Mustang, 1968-1971 Ford Ranchero and 1968-1971 Ford Torino. It's an unloaded front left caliper (brake pads not included). See the Buyer's Guide tab for the full engine-level fitment.

  • Durable pistons: resistant to cracking or pitting and built to handle great loads.
  • New EPDM seals: the rubber seals are replaced with new high-temperature EPDM rubber for extended life and optimum performance.
  • Corrosion protection: treated with a specially formulated rust inhibitor and kept in the original equipment finish.
  • Ready to bleed: new bleeder screws give trouble-free bleeding and a positive seal, and a plastic cap plug protects every brake port thread.
  • Included where applicable: mounting bracket, new banjo bolts, new washers, and new stainless steel hardware clips and mounting pins.

This A1 CARDONE caliper is a remanufactured Original Equipment unit. The remanufacturing process is earth-friendly, reducing the energy and raw material needed to build a new part by 80%. Because calipers work as a pair on an axle, replacing both sides together is good practice for even, balanced braking; this listing is for one caliper.

Interchange: C80Z2B121A

This part cross-references / interchanges with the following part numbers:

C80Z2B121A

Frequently Asked Questions

Is this caliper right for a 1968-1973 Ford Mustang?

Yes. The 18-4013 is a direct-fit front left replacement for the 1968-1973 Ford Mustang. Check the Buyer's Guide tab to confirm the exact brake configuration for your vehicle.

Is this a loaded or unloaded caliper?

It's an unloaded caliper, meaning brake pads are not included. You'll reuse your existing pads or install a new set separately.

Are the mounting bracket and hardware included?

The mounting bracket, banjo bolts, washers, and stainless steel hardware clips and mounting pins are included where the specific application calls for them.

Does this brake caliper come painted red?

No. The caliper is kept in the original equipment finish and treated with a specially formulated rust inhibitor.

Should I replace both calipers at the same time?

Calipers work as a pair on an axle, so replacing both sides together is recommended for even, balanced braking, though this listing is for a single caliper.