Clamp the pads against the rotor with steady hydraulic force using the A1 CARDONE brake caliper 18-4043, a remanufactured, unloaded caliper for the front right position. It fits many vehicles, among them the 1969 Chevrolet Camaro, 1969-1974 Chevrolet Nova and 1973-1974 Buick Apollo. See the "Vehicles it fits" section for the full list and engine details.
CARDONE remanufactures each caliper to rigorous quality and performance standards and fits it with new components, and every unit is 100% pressure-tested. It is supplied unloaded, so brake pads are not included.
- Pistons: durable, resist cracking and pitting, and handle heavy loads.
- Seals: replaced with new high-temperature EPDM rubber.
- Finish: treated with a specially formulated rust inhibitor and kept in the original equipment finish.
- New hardware: new bleeder screws for bleeding and a positive seal, plus a plastic cap plug over every brake port thread. Banjo bolts, washers, stainless steel hardware clips, mounting pins and a mounting bracket are included where applicable.
This disc brake caliper is a remanufactured original equipment part, intended to match the factory unit's fit. If a sticking piston, a fluid leak or a pull to one side traces back to the caliper, this unit replaces it. It is sold individually, and replacing both front calipers together is recommended for even, balanced braking. The earth-friendly remanufacturing process reduces the energy and raw material needed to make a new part by 80%.
Interchange: 5472434
Frequently Asked Questions
Does this Camaro brake caliper fit a 1969 Chevrolet Camaro?
Yes. It is listed for the 1969 Chevrolet Camaro in the front right position. Check the "Vehicles it fits" section for engine details.
What other vehicles does this caliper fit?
It also fits the 1969-1974 Chevrolet Nova and 1973-1974 Buick Apollo, among others. The "Vehicles it fits" section shows the full list.
Does it come with brake pads?
No. It is an unloaded caliper, so pads are sold separately. New bleeder screws are included, and banjo bolts, washers, clips, pins and a bracket are included where applicable.
What does a brake caliper do?
It uses hydraulic pressure from the brake fluid to push the pads against the rotor, which slows the wheel. This unit serves the front right position.
What are signs the caliper may need replacing?
Brake fluid leaking at the caliper, pulling to one side when braking, a dragging or sticking brake, or uneven pad wear can be signs of a caliper problem. Diagnose the cause before replacing.
