Replace a leaking or sticking rear left caliper with the A1 CARDONE brake caliper 18-4373. This remanufactured, unloaded unit is 100% pressure-tested and built with brand-new premium components. It fits many vehicles, among them the 2001-2006 Dodge Stratus, 1998-2004 Dodge Intrepid and 1991-1993 Dodge Dynasty. See the "Vehicles it fits" section for the full list.
The A1 CARDONE caliper is a remanufactured original equipment part, so it installs as a direct-fit replacement for the listed applications in the rear left position. It is sold unloaded, which means brake pads are not included.
- Pressure-tested build: Every caliper is 100% pressure-tested and is designed to deliver consistent brake performance. The pistons resist cracking and pitting and are made to handle heavy loads.
- Fresh seals and bleeders: The rubber seals are replaced with new high-temperature EPDM rubber. New bleeder screws allow trouble-free bleeding and seal positively.
- Corrosion protection: The caliper is treated with a specially formulated rust inhibitor and keeps its original equipment finish. A plastic cap plug protects every brake port thread for trouble-free installation.
- Hardware where applicable: A mounting bracket, new banjo bolts, new washers, new stainless steel hardware clips and new mounting pins are included where the application calls for them.
CARDONE's remanufacturing process uses 80% less energy and raw material than making a new part.
Signs a caliper may need replacing include brake fluid seeping near the wheel, a pull to one side under braking, a dragging wheel, or uneven pad wear. Diagnose the cause before replacing any part.
Interchange: 4423065 · 5011747AA · 5019743AA · 5019743AB
This part cross-references / interchanges with the following part numbers:
4423065, 5011747AA, 5019743AA, 5019743AB
Frequently Asked Questions
Is this the right 2001-2006 Dodge Stratus brake caliper?
It is listed for the rear left position on the 2001-2006 Dodge Stratus. It also fits the 1998-2004 Dodge Intrepid and 1991-1993 Dodge Dynasty. Check the "Vehicles it fits" section for your exact vehicle.
What does a disc brake caliper do?
When you press the pedal, hydraulic pressure pushes the caliper piston so the brake pads clamp the rotor and slow the wheel. This unit serves the rear left position.
Does this caliper come with brake pads?
No. It is an unloaded caliper, so pads are sold separately. New bleeder screws are included, and a bracket, banjo bolts, washers, clips and pins are included where applicable.
How is this caliper remanufactured?
Its rubber seals are replaced with new high-temperature EPDM rubber. The caliper is treated with a rust inhibitor, kept in its original equipment finish, and 100% pressure-tested.
What are signs a brake caliper may need replacing?
Common signs include brake fluid leaking near the wheel, pulling to one side, a dragging wheel, or uneven pad wear. Diagnose the cause before replacing the caliper.
