Clamp the brake pads against the rotor with hydraulic force using the A1 CARDONE Remanufactured Disc Brake Caliper 18-B4877 — a direct-fit replacement among Dodge Durango calipers for the 2003 Dodge Durango. This is an unloaded caliper supplied w/Bracket, meaning it includes its mounting bracket but ships without brake pads. If a seized, leaking, or sticking caliper is the cause of your uneven braking, dragging, or fluid seepage, this unit replaces it.
- Durable piston: resistant to cracking or pitting and built to handle great loads.
- New EPDM seals: rubber seals are replaced with new high-temperature EPDM rubber for extended life and consistent performance.
- 100% pressure-tested: each remanufactured unit is pressure-tested and arrives with new hardware, plus new banjo bolts, bleeder screws, and washers where applicable.
- Corrosion protection: treated with a specially formulated rust inhibitor and kept in the original equipment finish.
Every brake port thread is protected by a plastic cap plug for a trouble-free installation, and new stainless steel hardware clips and mounting pins are included where applicable. CARDONE's remanufacturing process is earth-friendly, cutting the energy and raw material of a new part by 80%. A dependable A1 CARDONE caliper for the listed application.
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
Does this caliper fit my 2003 Dodge Durango?
Yes. The A1 CARDONE 18-B4877 is a direct-fit replacement for the 2003 Dodge Durango. Confirm your vehicle in the "Vehicles it fits" section before ordering.
Is the mounting bracket included?
Yes. This is an unloaded caliper supplied w/Bracket, so the mounting bracket is included for a straightforward installation.
Are brake pads included with this caliper?
No. "Unloaded" means the caliper ships without brake pads. Reuse or replace your pads as directed by the service procedure.
What hardware comes with the caliper?
It arrives with new hardware, and new banjo bolts, bleeder screws, washers, stainless steel clips, and mounting pins are included where applicable.
Should I replace both calipers at once?
Replacing the calipers on the same axle as a matched pair is good practice for even, balanced braking. This listing is for one caliper.
Reviews
No reviews yet — be the first to review this product.
Write a ReviewWrite a Review