CARDONE Reman Disc Brake Caliper P/N:18-B5075
Designed to press the brake pads against the rotor at the front right wheel, the A1 CARDONE 18-B4911 remanufactured disc brake caliper is a direct-fit replacement for the 2004-2008 Chevrolet Malibu, 2006-2011 Chevrolet HHR and 2006-2008 Pontiac G6. It comes as an unloaded caliper with the mounting bracket included, so the brake pads are sold separately.
CARDONE remanufactures each unit to strict quality and performance standards and equips it with new components. Every A1 CARDONE brake caliper is 100% pressure-tested to help deliver consistent brake performance.
Where the application calls for them, new banjo bolts, washers, stainless steel hardware clips and mounting pins are also supplied. Because each unit starts as an original equipment caliper, it is built to match the original fit. The remanufacturing process also cuts the energy and raw material needed to make a new part by 80%. This listing is for one front right caliper; replacing both calipers on the same axle together is recommended for even, balanced braking.
Interchange: 22705314
This part cross-references / interchanges with the following part numbers:
Is this the right brake caliper for a 2004-2008 Chevrolet Malibu?
It is listed for the front right position on the 2004-2008 Chevrolet Malibu. See the Buyer's Guide tab for the full fitment chart.
Does it also fit the 2006-2008 Pontiac G6 and the 2006-2011 Chevrolet HHR?
Yes, it is listed as a front right caliper for the 2006-2008 Pontiac G6 and the 2006-2011 Chevrolet HHR.
What comes with this A1 CARDONE caliper?
It ships as an unloaded caliper with the mounting bracket, a new bleeder screw and a plastic cap plug on each brake port thread. Brake pads are not included; other hardware is supplied where the application needs it.
What are signs a brake caliper may need replacing?
Common signs include pulling to one side when braking, fluid leaking at the caliper, a dragging or sticking brake, or uneven pad wear. Diagnose the cause first, as other brake parts can cause similar symptoms.
Does the caliper need bleeding after installation?
Yes, the brake system should be bled after installing a caliper, following the vehicle service information. The new bleeder screw is designed for trouble-free bleeding and a positive seal.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.