Rear Right Brake Caliper for 2003-2006 Chevrolet Express 2500 & More - A1 CARDONE 18-B4931

$90.99

Vehicles this part fits

    Part number: 18-B4931
    UPC: 082617684217
    Weight: 16.80 LBS
    Item Package Quantity: 1
    $90.99
    Adding to cart… The item has been added

    Have questions?

    CARDONE Reman Disc Brake Caliper P/N:18-B4931
    CARDONE Reman Disc Brake Caliper P/N:18-B4931
    $90.99
    $90.99

    A1 CARDONE 18-B4931 rear right brake caliper for the 2003-2006 Chevrolet Express 2500 and other vehicles clamps the pads against the rotor to slow the wheel. It is a remanufactured, unloaded unit that comes with its bracket.

    • Rebuilt with brand-new components and 100% pressure-tested
    • Phenolic pistons resist cracking and pitting and handle great loads
    • Rubber seals replaced with new high temperature EPDM rubber
    • Special formulated rust inhibitor treatment on the caliper
    • New bleeder screws for trouble-free bleeding and a positive seal, plus a plastic cap plug on every brake port thread
    • New stainless steel hardware clips and new mounting pins where applicable

    Quick facts

    • Part: A1 CARDONE 18-B4931 brake caliper
    • Also called: disc brake caliper
    • Fits: 2003-2006 Chevrolet Express 2500 and other vehicles
    • Position: Rear right
    • Material: Cast iron
    • Condition: Remanufactured

    A rear caliper that sticks or leaks can show up as the car pulling to one side, uneven pad wear or fluid wetness at the wheel, but a binding slide or a collapsed hose can pull a car the same way. Find the cause before replacing the caliper; a shop can check the slides, pins and hoses for binding or restriction. Rear calipers are normally replaced as a pair, and this listing is one caliper.

    Fits

    It fits the 2003-2006 Chevrolet Express 2500 and the 2003-2006 GMC Savana 2500.

    Specifications

    Fit and size

    • Position: rear right
    • Quantity per vehicle: 1 (rear right)
    • Number of pistons: 2
    • Piston diameter: 44.2722 mm (1.743 in)
    • Mounting hole diameter: 13.98989 mm (0.551 in)
    • Mounting hole thread: M14 X 2.0
    • Inlet fitting: banjo, 10.00366 mm (0.394 in), thread M10x1.0
    • Bleeder thread: M10x1.0

    Build and materials

    • Caliper type: floating
    • Condition: remanufactured, unloaded
    • Caliper casting material: cast iron
    • Piston material: phenolic
    • Finish: oil emulsion, with a rust resistant coating
    • Country of origin: Mexico

    In the box

    One caliper with its bracket, a hardware kit and an instruction sheet. Brake pads, mounting bolts and bleeder screw caps are not included, so plan on new mounting bolts rather than reusing the old ones. This listing holds one rear right caliper, and that side takes one; the rear left is ordered separately.

    Installation notes

    • Programming is not required.
    • Use the brake fluid the vehicle's maker recommends; the type is stamped on the master cylinder reservoir lid, and it should come from a new, sealed container.
    • The instruction sheet in the box covers the steps.

    Interchange: 15751174

    This part cross-references / interchanges with the following part numbers:

    15751174

    Frequently Asked Questions

    Does this A1 CARDONE caliper fit the 2003-2006 GMC Savana 2500?

    Yes. A1 CARDONE 18-B4931 is a rear right caliper that fits the 2003-2006 GMC Savana 2500, as well as the 2003-2006 Chevrolet Express 2500.

    Does this remanufactured disc brake caliper come with brake pads?

    No. A1 CARDONE 18-B4931 is an unloaded caliper, so pads are not included. The bracket, hardware kit and instruction sheet come with it; mounting bolts do not.

    What are the pistons made of on this A1 CARDONE brake caliper?

    This caliper has two phenolic pistons, each 44.2722 mm (1.743 in) across. Its rubber seals are new high temperature EPDM.

    What causes brake squeal after a caliper change?

    Squeal can come from pads installed incorrectly, brake hardware installed incorrectly or an improper rotor finish. If it keeps up, have a shop look at the brakes.

    What grease goes on the mounting pins of a floating caliper like this one?

    A silicone grease is used on floating caliper mounting pins. A1 CARDONE 18-B4931 is a floating-type caliper.

    Reviews

    No reviews yet — be the first to review this product.

    Write a Review