A1 CARDONE 18-B4961 front right brake caliper for the 2004-2007 Ford Freestar and other vehicles is remanufactured and clamps the pads against the rotor. This A1 CARDONE caliper is unloaded, so it arrives without brake pads, and it comes with its bracket.
- Two phenolic pistons that resist cracking and pitting and handle heavy loads
- New high-temperature EPDM rubber seals replace the old ones
- Every unit is 100% pressure-tested
- Rust-inhibitor treatment on the caliper body
- New bleeder screw for trouble-free bleeding and a positive seal
Quick facts
- Part: A1 CARDONE 18-B4961 brake caliper
- Also called: disc brake caliper
- Fits: 2004-2007 Ford Freestar and other vehicles
- Position: Front right
- Material: Aluminum (caliper casting)
- Condition: Remanufactured
A sticking or leaking caliper can show up as the car pulling to one side, a dragging brake or uneven pad wear. Worn hoses or suspension parts can produce similar symptoms, so during a brake service, look over the slides, pins and boot for binding or fluid before you blame the caliper.
Fits
This is a brake caliper for the 2004-2007 Ford Freestar and the 2004-2007 Mercury Monterey, made for the front right. The listing is one caliper; the front left is a separate part and is normally replaced together with this one. The front axle takes one caliper per side.
Specifications
Fit and size
- Position: Front right
- Quantity per application: 1
- Piston quantity: 2
- Piston diameter: 2.003 in (50.8762 mm)
- Mounting hole diameter: 0.551 in (13.98989 mm)
- Mounting hole thread size: M14 X 2.0
- Inlet port size: 0.394 in (10.00366 mm)
- Inlet fitting: banjo, thread M10x1.5
- Bleeder thread size: M10x1.0
Build and materials
- Caliper type: floating
- Condition: remanufactured, unloaded (pads not included)
- Casting material: aluminum
- Piston material: phenolic
- Finish: oil emulsion, with a rust-resistant coating
- Country of origin: Mexico
In the box
One caliper, a bracket, a hardware kit and an instruction sheet. Brake pads, a pad wear sensor and mounting bolts are not included, so plan on new mounting bolts rather than reusing the old ones.
Installation notes
- A plastic cap plug protects each brake port thread until installation.
- Silicone grease is used on floating caliper mounting pins.
- No programming is required.
Interchange: 3F2Z2B120SA · 6F2Z2B120A
Frequently Asked Questions
Does this A1 CARDONE brake caliper fit the 2004-2007 Mercury Monterey?
Yes. A1 CARDONE 18-B4961 is a front right caliper for the 2004-2007 Mercury Monterey and the 2004-2007 Ford Freestar.
What comes with the 18-B4961 caliper, and what is left out?
A1 CARDONE 18-B4961 comes with the bracket, a hardware kit and an instruction sheet. Brake pads, a pad wear sensor and mounting bolts are not included.
Can I swap this disc brake caliper for a steel piston one?
No, swapping piston types is not recommended. This caliper has phenolic pistons, and the installer should follow the vehicle manufacturer's recommendation on piston type.
What brake fluid do I use after installing this caliper?
Use the brake fluid the vehicle maker recommends; the type is stamped on the master cylinder reservoir lid. Always use new fluid from a sealed container.
Does 6F2Z2B120A cross to this caliper?
Yes. A1 CARDONE 18-B4961 replaces 6F2Z2B120A, and it also replaces 3F2Z2B120SA.
