Keep steady hydraulic clamping force at the front wheels with the A1 CARDONE brake caliper, part number 18-B5017, a remanufactured unloaded caliper supplied with its mounting bracket. It fits many vehicles, among them the 2006-2011 Dodge Charger, 2005-2011 Chrysler 300 and 2009-2011 Dodge Challenger, and is cataloged for both the front left and front right positions.
CARDONE remanufactures each unit to its quality and performance standards and fits it with new components. Every caliper is 100% pressure-tested for consistent braking performance. As a remanufactured original equipment disc brake caliper, it is a direct-fit replacement for the listed applications.
- New EPDM seals: The rubber seals are replaced with new high-temperature EPDM rubber.
- Durable pistons: The pistons resist cracking and pitting and are built to handle heavy loads.
- Rust protection: The caliper is treated with a specially formulated rust inhibitor and kept in its original equipment finish.
- Install-ready: The mounting bracket is included. New bleeder screws make bleeding easier and give a positive seal, and a plastic cap plug protects each brake port thread. New banjo bolts, washers, stainless steel hardware clips and mounting pins are included where applicable.
Because it is an unloaded caliper, brake pads are not included. Replacing both front calipers together is recommended for even, balanced braking. Signs that a caliper may need replacing include fluid leaking at the caliper, a pull to one side under braking, a dragging brake, or uneven pad wear. The remanufacturing process is earth-friendly, cutting the energy and raw material needed to make a new part by 80%. See the Buyer's Guide tab for the full list of vehicles and engines.
Interchange: 5137671AA · 5137671AB
