The A1 CARDONE brake caliper, part number 19-920, is a remanufactured, unloaded front right caliper that clamps the brake pads against the rotor when you press the pedal. It fits many vehicles, among them the 1988-1991 Mercedes-Benz 300SE, the 1988-1991 Mercedes-Benz 300SEL and the 1991 Mercedes-Benz 350SD. It is a direct-fit replacement for the listed applications. See the Buyer's Guide tab for the full list and engine details.
- Pressure-tested: CARDONE remanufactures each caliper to strict quality and performance standards with brand-new premium components, and every unit is 100% pressure-tested.
- New EPDM seals: The rubber seals are replaced with new high-temperature EPDM rubber.
- Tough pistons: The pistons are durable, resist cracking and pitting, and are built to handle heavy loads.
- Rust protection: Each caliper is treated with a specially formulated rust inhibitor and kept in its original equipment finish.
- New hardware: A new bleeder screw gives easy bleeding and a positive seal. The mounting bracket, banjo bolts, washers, stainless steel hardware clips and mounting pins are included where applicable. A plastic cap plug protects each brake port thread until installation.
This A1 CARDONE caliper is a remanufactured original equipment unit. It is sold unloaded, so brake pads are purchased separately. Signs that a caliper may need replacing include brake fluid seeping at the caliper, the vehicle pulling to one side under braking, a dragging brake, or uneven pad wear. Diagnose the cause first, because hoses, pads and other brake parts can produce similar signs. Bleed the brake system after installation, following the vehicle service information. CARDONE's remanufacturing process uses about 80% less energy and raw material than making a new part.
Interchange: 0986471865 · 1264200783
